11 Quick and Easy Home Repairs under $25 (Project 6)

Whether you’re a fledgling do-it-yourselfer or a veteran, here’s a collection of home repairs and fix-ups you can do in a few hours or less for under $25 each as posted by The Family Handyman online at Reader’s Digest.

Broken storm door handles are easy to replace if you buy the same kind, but upgrading to a top quality brass handle as we’ve done takes a little extra work. At first glance, it appeared that this handle would fit in the old holes. A closer look at the instructions revealed that the handle had to be shifted slightly away from the edge of the door. Rather than attempt to enlarge the holes and risk a sloppy fit, we moved the handle down slightly and drilled new holes. The manufacturer had anticipated this problem and provided a cover plate to conceal the old holes on the inside of the door.

You’ll need a drill with 1/8-inch and 5/16-inch bits and a Phillips screwdriver to complete this job. We purchased the replacement handle at a large home center for about $24. There are a few different styles available. You can even buy a matching deadbolt if you like the idea of locking your storm door.

Remove the old storm door handle by unscrewing the two screws that hold the two halves together. Mark the door for the new hole locations using the template provided with the new door handle. Position the template so the new holes do not land over the existing holes.

Drill 1/8-inch pilot holes through the door at the locations you marked with the template. Then enlarge these holes to 5/16 inch by drilling halfway through the door from both sides with a 5/16-inch drill bit. Assemble the door handle according to the instructions. Screw the two halves together with the machine screws provided. Start the screws by hand to make sure the threads are aligned before tightening them with a screwdriver.

Close the door and hold the strike plate in position while you mark the screw slots. Remove the plate and drill 1/16-inch pilot holes in the center of each slot mark. Use the plastic shims provided to shim the plate if necessary. Then screw it to the door frame. Adjust the strike plate until the door latches firmly, then tighten the screws.

Popularity: 9% [?]